Removing an Engine Appliance in UVB 8.0


Procedure to cleanly remove an engine appliance that is no longer needed.


If you decide you no longer need a specific engine appliance in your environment and would like it completely removed, use the following steps to ensure it is removed cleanly and no longer included in any UVB reporting:

  1. On the Configure page, remove any data stores associated with the appliance.
  2. Next, use the hypervisor client and power down the appliance virtual machine.
  3. Use the hypervisor client again to remove the appliance VM and any associated disks.
  4. In the UVB interface, run an Inventory Sync.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Contact us